Corridor Lamp RGFL214

Parameters

Input Voltage: AC/DC24-220V
Frequency:50Hz
Light source: gas discharge lamp
Light source: LED
Anti Corrosion: WF2
Power:24W
The introduction of cable: Φ6～8mm
Dimensions:203*175*204mm
Ingress Protection Rating:IP65
Weight:1.7Kg

Application

Suitable for no-explosion coal mine deputy roadway, facility tunnel, pedestrian tunnel or corridor and other narrow environments for lighting .special fit for low-rise environments, for example: large equipment warehouse, large machine table etc.

Features & Benefits

1. narrow ring type and symmetry ring type, satisfied to different demands.
2. Advanced optical design for transparent part, sofe and uniform lighting, control glare efficiency , reduce visual fatigue.
3. Light source have cool white and warm white, no frequency flash, energy-saving and environmental protection
4. Good heat dissipation design, light cavity and electrical cavity independent, control the temperature well , prolong the life of LED and other electrical element ,ensure which is can be work stably .
5. High strength aluminum alloy shell and spray technology of surface, anti corrosion.
6. Advanced structure design, which is water and dust proof
7. Small volume and lightweight , shock proof .
8. Multiply installation: Ceiling type, wall type, rings type and pendant type, satisfied to different occasion lighting.
9. LED for light source, longevity,  the service  life more than 50000 hours.
10. LED, high brightness, power consumption is equal to about 12.5% of incandescent lamp luminous flux
11. High voltage and low voltage can be choose, the range of low voltage :AC/DC30～45V, range of high voltage: AC/DC85～260V, satisfied to multiple voltage : AC/DC36V,AC/DC110V,AC/DC127V,AC/DC220V

Method of use:
1. equipped 0.5mm cable convenient for installation.
2. If the cable not enough please prepareΦ6～8mm three core cable.
3. Pull the key lock and open the cover, the three-core cable ready , according to wiring seat marked positive , FireWire connection L side, zero line N-terminal end of the ground wire to ground , and then into the mouth after the restraining cable connectors Glenn Close the closing lid , fasten the lock , and finally the other end of the three-core cable connected, you can achieve lighting
Notice:
1.low voltage type can be work: AC/DC30～45V , the best work voltage range:35V±5%, high voltage type can be work: AC/DC85～265V, satisfied to different voltage demands: AC/DC110V,AC/DC127V,AC/DC220.
2. If the number of low-pressure lamps lighting a loop more, please ensure that the main line of the conductor loop area has sufficient space , it is recommended : use 4mm² copper cable loop , lamps spaced 10m, can’t afford over the number of lamps 15 sets, using a 6mm² copper cable loop , lamps spaced 10m, lamps can’t afford more than 20 sets of loops to avoid excessive pressure drop caused by poor lighting start or self-extinguishing
3.narrow ring type not fit for the method of rings.