We are pleased to introduce ourselves as a factory established in 1993, Sharjah – United Arab Emirates. Gulf Cool Therm Factory LLC is an ISO 9001:2008 Certied Company with Quality System certied by UKAS of United Kingdom.

Gulf Cool Therm Factory LLC, is a leading manufacturers and suppliers of high quality:

Thermal Insulation Materials

• Pre-insulated Pipes and Fittings for District Cooling Application
• Polyisocyanurate Pipe, Duct, Slab and Vessel/Equipment Insulation
• Polyurethane Pipe, Slab and Vessel/Equipment Insulation
• Class ‘O’ CFC & HCFC Free Phenolic Foam Pipe, Duct, Wall and Roof Insulation
• Continuous PIR/PUR Foam Block Production
• Cold Insulation Materials for LNG, Oil and Gas Industries
• Foam Glass Insulation
• Phenolic Foam / Polyisocyanurate Pre-insulated Air Duct Panels
• Roof and Wall Insulation
• Polyurethane Spray Applied Foam
• High Density Thermal Support Inserts for piping and Ducting
• Heat Exchanger Insulated Box and Tray
• Field Joint Insulation and Application

With many CNC Foam cutting machineries and production process units in the eld with quality material available, highly qualied technical and commercial sta. We are condent that our product will comply with all international standard and denitely will meet your requirements.

In order to facilitate our client with best service and respect to quality, prompt delivery, respective elements of production and marketing were provided and enhanced under a tight quality control.

FIELD INSULATION
When a Underground piping is constructed, the 6/12 meters long pipes/ttings are jointed together after they are laid down and the pressure test is completed. Start by placing the jacketing in position, Check space around and in between the pipes to see that adequate space is available for quick and easy installation without use force.

A 0.7 mm or 0.9 mm G.I sheet roll up around the joint and riveted (Use stainless wire/belt to avoid any bulging during foaming) Then the Polyurethane foam or Polyisocyanurate foam Chemical is poured through the drilled
holes into the G.I sheets.

POURING OF THE FOAM CHEMICALS
Polyurethane/Polyisocynaurate foam consists of two components: Polyol and Isocyanurate (ISO/MDI) for the eld joint insulation.

The chemicals temperature should always be maintained at 20° - 25°C.

After the GI casing is installed, weight the exact amount of chemicals, Polyol & Isocyanate (ISO/MDI), in separate cups. Please note that Polyol with a pale-to-dark yellow colour and ISO is colored black. Both chemicals should not be exposed to air-moisture or heat for long hours. Make sure the chemicals containers are closed tightly after usage.

First, pour the Polyol (weighed in a cup) into mixing cup/bucket. When ready to mix, pour the ISO (weighed in a cup) into mixing cup/bucket with Polyol and using electric drill with mixer blade attached, mix the two chemicals for 10-15 seconds. Make sure the chemicals are thoroughly mixed. When the colour of the mixture changes (from dark to pale yellow) pour immediately (as quickly as possible) the mixture through the
pouring hole on the top of jacket. Allow few minutes for the foam to rise, then, plug the pouring hole to refrain rising foam from coming out of the hole.