Devtech Megasaver (DMS) is an unique energy saving product used to drive High intensity Discharge lamps (MH / HPS / CMH/ CDM – T/ CXL). It is a retrofit, single box solution which replaces conventional ignitor, PF capacitor, magnetic coil. It gives a constant light output for wide range of input voltages, lower THD (less than 10%) and Power Factor of near Unity (>0.98). The USP of the product is it can match the Lumen level of existing higher wattage lamps with Devtech Megasaver of lower wattage. Example 400W Magnetic Ballast with 400w HID lamp can be replaced with 250W Devtech Megasaver and 250w HID lamp to give similar lumen levels thus saving 40% energy. DMS is also protected for all the vulnerabilities like Short circuit, transient surge, inrush current. Devtech Megasaver is available in ratings like 35 to 400 Watts. This product ensures energy savings up to 40% under most of the operating conditions . Devtech Megasaver can be placed at a distance of 50 meters from lamp so serviceability is an easy task. Pre-programmed scheduling of lamps can be achieved through easy settings.The product can be supplied with IP65 Ingress protection rating. This product is backed by Two Year replacement guarantee.

Product Description

• Energy efficient Low Frequency Controller for HPSV/MH/COD–T lamp types
• Retrofit one box solution that replaces Ballast, PF improvement Capacitor & ignitron
• Constants Power Output to Lamp over a wide input voltage range(90V ~ 305V AC)
• High power Factor with value > 0.98
• Low Harmonic Distortion with THD value < 10%
• MEGA Lumen switch feature which boost the lamp lumen output by 10% when the switch is activated
• Controller can be located at distance of 15 meters from lamp for easy maintenance access
• DIP Switch with 8 levels of pre-programmable settings to adjust the lighting levels & increase energy savings.
• Energy savings upto 30-50%.
• ASIC and Embedded DSP Control for Ballast and Lamp protection and Dimming
• Thermal Silicone Potting/encapsulation for trouble free operation in hostile environments for outdoor and indoor installations.
• Aluminium Extrusion anodized casing with fins for proper heat dissipation.
• Flicker free lamp operation.
• Maximum lamp life as a result of optimal lamp operation
• Lamp power and current control.
• Controlled ignition time interval (21 sec High & 64 sec Low) attempt stops after 20 minutes. Main supply must be switched OFF and ON to reset the ballast.
• Compliant to EMI/EMC, Safety and CE Standards
• Comprehensive warranty.

Protection Features

• External 10kV/5kA Surge Protection Device (Model – DSG 1510)
• Lamp over voltage protection & shutdown
• Lamp under voltage protection & shutdown
• Lamp short circuit/Warm-up failure protection & shutdown
• Open circuit/No-lamp protection & shutdown
• End-of-lamp-life (EOLL) detection & shutdown

Current Regulation Feature

• The lighting levels can be set 100% 95% 90% 85% 80% 75% & 65%values using the switch provided on the controller
• MEGA Lumen switch feature which boost the lamp lumen output by 10% when the switch is activated.
• The above feature is achieved using current regulation