Gas-heated tunnel finisher based on the Omega principle with integrated energy recovery system
The Omega principle

S-shaped entrance zone acting as a pre-heating and steaming chamber
S-shaped cool down and exit area
Perfect finishing quality with new Jet air flow system

Adapted air nozzles
Optional pocket blowers

CleanTech Gas technology for a higher efficiency

A separately adjustable gas burner is integrated in the center of each drying chamber and injects the heat into the circulated air through a specially developed distribution tube that points at a high-temperature baffle for ideal heat insulation.

The Omega Pro Gas features not only individual temperature control but also separately adjustable inlet and exhaust air parameters per drying zone.

Energy recovery system to reduce energy costs

Incoming garments are heated up in the inlet zone by using recirculated hot air from the drying and outlet zone.

The saturated air is reduced to a minimum and exhausted through one air fan instead of two at the point where the air has the highest degree of water saturation.

Savings:
Reduction in local energy supply of up to 25% compared with the previous model Omega Plus