Each configuration requires a hardware kit and tie bar kit(s), with the exception of the single engine configuration.
GENERAL INSTALLATION NOTES FOR CHART ABOVE 1) Installation may vary according to the following factors: engine mounting height, transom thickness, use of transom savers, tiller bolt hole location, engine tilt range, and engine size. 2) For center engine drops greater than 3 inches (76mm), please consult Teleflex Technical Service. 3) Tie bar length may vary depending on toe in/toe out setup. To allow for toe, add or subtract from your nominal engine center to center distance. 4) Based on recommended engine manufacturer minimum center to center distances. Deviating from these recommendations may require stroke limiting cylinders and/or engine tilt limiting, please consult Teleflex Technical Service. 5) Cylinder's must be plumbed in parallel only, no series connections. Only exception is if cylinders are utilizing a liquid tie bar.